YZ917 Two-way PD Mobile Power DIY Car Charger 60W Full Protocol Circuit Board Two-way Fast Charge PD Protocol PD60W

Origin:Mainland China

modname=ckeditor
This circuit is only a DIY mobile power circuit board, not a finished mobile power supply.
The SC8802 chip series are not resistant to static electricity. Do not touch the circuit with your hands to avoid static electricity interference and damage.
Be sure to connect the lithium protection board during testing and use to prevent short circuit burns!
60W refers to the pd broadcast 20V3A60W, the module has the ability to output 20V3A full 60W, it does not mean that you must plug in your device to have a constant power output of 60W.
The charging input constant current is about 2.5a, and it is recommended to use a 60W PD power supply for charging.
There is only one Type-C port and no USB-A port.
Ultra-small size, 50X25X13mm.
Two-way 60W super power, fast charging without waiting. Two-way buck-boost, input 12v can also output 20v60W, input 5V can also charge 4 strings of lithium batteries.
Synchronous rectifier buck-boost main control + four imported MOS.
DIY notebook two-way PD mobile power artifact, you only need to bring your own 4 strings of lithium batteries with protection function to connect the positive and negative poles.
IP2716 full protocol 60W fast charge output, the output not only supports laptop computers but also compatible with almost all mobile phone fast charge protocols.
Single Type-C port, two-way PD, input constant current 2.5A or so to prevent the power supply, automatically apply for PD20V3A, it is recommended to use a PD adapter above 60W to charge.
The output constant current is about 4A, the maximum output is 60W, all protocols (except VOOCDASH) support, SWITCH, Apple 8 8P X, and Apple notebooks are fully compatible!
The voltage defaults to 4 strings, the full-charge voltage is 16.8V, and it stops automatically when it is full.
1 indicator light, red = fast charging output or reverse charging is fully charged, blue = reverse charging in progress. The circuit has no under-voltage protection, so a with a protection board must be used. Remember!
The terminals of multiple boards can be directly connected in parallel, which supports simultaneous charging and discharging of multiple modules, or charging and discharging UPS mode one by one.