Specifications: Material: Plastic outer shell
Output limitation (each port):
Addressable RGB port: 72 LED per port, total 5V, 5A
Fan Port : total 12V, 3A
Color Selection: Support 2812 IC Addressable RGB LED
Signal output:
Standard Addressable RGB 3pin + 4-1pin x 6*
Fan 4pin port x 4 (compatible with 3pin)
Included Parts:
6 x Standard Addressable RGB cable
1 x Peripheral power Y cable
1 x RF remote
1 x Thermal sensor cable
1 x Power switch cable
Specifications: Includes Accessories:
MicroScanner2 Cable Verifier
main wiremap adapter
remote identifiers #2-7
IntelliTone Pro 200 probe
shielded twisted-pair RJ45 patch cord
RJ11 patch cord
clip-set RJ45 to 8 alligator clip bare wire adapter
F Coax push on patch cord
accessory soft pouch
(2) AA alkaline batteries
(1) 9V alkaline battery
MicroScanner2 Getting Started Guide
MicroScanner2 Owners CD
IntelliTone Pro Getting Started Guide
MicroScanner2 owners CD
IntelliTone Pro Getting Started Guide
IntelliTone Pro owners CD
packaged in a deluxe Fluke Networks carry case
Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board.
These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases.
Pure copper heatsink thermal conductivity up to 401w / mk,good idear for processor,CPU and GPU cooling,Tested to fit the Raspberry Pi CPU / SoC,reduce the risk of hardware failure due to overheating.
These heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips.
These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc.
Installation Instructions:
-Make sure the chip modules are free from dirt and gre...
Specifications: Color: White
Material: Plastic strip with 15 LED(3.6W) and adhesive tape
Operating system support: 12V
Connectors:
Peripheral to LED 4pin connector x 1
4pin daisy chain connector x 1
Length: 300mm
Weight: 22g