Mobile Rack Drives Support: Multi 2.5" Drives to 5.25" Bay
Mobile Rack Interface: SATA I/II/III
Specifications: Host Interface: 7 pin SATA x 4
Drive Fit: 2.5" SATA I / II / III SSD or hard drive x 4
Drive Bay: Single 5.25" half height device bay
Transfer Rate: Up to 6 Gb / sec. (depending on hard drive speed)
Insert& Extract connection Via: Direct SATA hard drive connection
Structure: SECC
Device Power: Single 4 pin Molex power
Drive Cooling:
Dual 40mm rear cooling fan + fan power switch
Metal heat dispersion
Power Indicator: Solid Green LED
HDD Access Indicator: Flashing Amber LED
Dimension (L x W x H): 6.70" x 5.75" x 1.63"
Weight: 1.77 lbs.
Specifications: Average Particle Size:
<0.49 micron <0.000020 inch
Extended Temperature Limits:
Peak: -50 Degrees C to >180 Degrees C
Long-Term: -50 Degrees C to 130 Degrees C
Performance:
3 to 12 degrees centigrade lower CPU full load core temperatures than standard thermal compounds or thermal pads when measured with a calibrated thermal diode imbedded in the CPU core.
Coverage Area:
A 3.5 gram syringe contains enough compound to cover at least 15 to 25 small CPU cores, or 6 to 10 large CPU cores, or 2 to 5 heat plates. At a layer 0.003" thick, the 3.5 gram syringe will cover approximately 16 square inches.
Size: Please Note As Hot Plug only means that the PC doesn't have to be restarted after disk swaps, it is crucial to disconnect and switch off the docking station before removing and changing any disk drives, to avoid data loss and structural damage. Please make sure the device is powering