Specifications: Standards:
IEEE 802.3
IEEE 802.3u
IEEE 802.3x
IEEE 802.3ab
IEEE 802.3af
IEEE 802.3at
Device Interface:
1 x Gigabit PoE/PoE+ in port
1 x Gigabit PoE/PoE+ out port
1 x Power port (optional power adapter is not included)
LED indicators
Installation mounting points
Data Transfer Rate:
Ethernet: 10 Mbps (half duplex), 20 Mbps (full duplex)
Fast Ethernet: 100 Mbps (half duplex), 200 Mbps (full duplex)
Gigabit: 2000 Mbps (full duplex)
Power:
Powered by PoE/PoE+ Device
Consumption: 2 Watts (max.)
Specifications: Interface:
PoE (Power + Data) Input Port: 1 x RJ-45 STP
Data” Output Port: 1 x RJ-45 STP
DC Out Plug Connector: 1
LED Indicator System: PoE In x 1 (Green)
Network Cable:
10Base-T: 2-Pair UTP Cat. 3, 4, 5, up to 100m (328 ft.)
100Base-TX: 2-Pair UTP Cat. 3, 4, 5, up to 100m (328 ft.)
1000Base-T: 2-Pair UTP Cat. 5, 5e, 6 up to 100m (328 ft.)
EIA / TIA-568 100-ohm STP (100m)
Data Rate: 10/100/1000 Mbps (varies on Ethernet device attached)
DIP Switch: 12V DC / 24V DC output voltage
Power Input: 802.3at PoE+ 52 ~ 56V DC
PoE Standard: IEEE 802.3at High Power over Ethernet
Number of clients device can be powered: 1
Power Output:
12V DC, 2A max
24V DC, 1A max
Standards Compliance:
IEEE 802.3 10Base-T Ethernet
IEEE 802.3u 100Base-TX Fast Ethernet
IEEE 802.3ab 1000Base-T Gigabit Ethernet
IEEE 802.3at...
Specifications: Ethernet Interface:
Copper:
10/100BASE-TX RJ45
auto-negotiation / auto-MDI / MDI-X
Power over Ethernet Standard: IEEE 802.3at/af PoE PSE (Power Source Equipment)
PoE Output: 56V DC, 600mA max.
PoE Budget: Up to 25 watts
PoE Mode: End-span, RJ45 Pin 1/2 (+), 3/6 (-)
Data Rate: 100/100 Mbps
Cabling: Cat5e or above
Maximum Distance: 100 meters
Maximum Frame Size: 1522 bytes
LED Indicators:
4 x LEDs
PWR
LRP LNK
PoE-in-use
LNK / ACT
ESD Protection: 4KV DC
Enclosure: Metal case
Installation: Wall mount or DIN rail with optional kit
Power Requirements: BNC Power over Coaxial Input: 44~56V DC
Standards Compliance:
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3af Power over Ethernet (802.3at Type 1)
IEEE 802.3at Power over Ethernet Plus(802.3at Type 2)
Specifications: Interface:
"Data" Input Port: 1 x RJ-45 STP
"PoE (Data+Power)" Output Port: 1 x RJ-45 STP
Input power terminal block: 1
LED Indicator:
System: Power 1, Power 2, Fault (Green)
PoE Port: PoE in Use x 1 (Green)
Network Cable:
10Base-T: UTP Cat. 3, 4, 5, up to 100m (328 ft.)
100Base-TX: UTP Cat. 3, 4, 5, up to 100m (328 ft.)
1000Base-T: UTP Cat. 5, 5e, 6 up to 100m (328 ft.)
EIA/TIA- 568 100-ohm STP (100m)
Data Rate: 10/100/1000Mbps
Dimension: 1.26" x 5.31" x 3.46"
Weight: 1.05 lbs.
Unit Input Voltage: 24 - 48V DC; 24V AC
Power Consumption: 30 watts max.
Number of device can be powered: 1
Installation: DIN rail kit and wall mount ear
Alarm:
Provides one relay output for power failure,
Alarm relay current carry ability: 3A at DC 30V
Enclosure: IP30 slim type metal case
Power over Ethernet
PoE Standard: IEEE 802.3at High ...
Specifications: Power-over-Ethernet (PoE) adapter for products with 10/100/1000-BaseT PoE inputs.
Indoor-rated.
Supports power up to 60W.
Input: 100 - 240V AC, 50 / 60 Hz 1.0A
Output: 48V DC 1250 mA (60W)
Data port: RJ-45 jack
PoE/data port: RJ-45 jack
Dimension: 4.84" x 2.40" x 1.57"
Kit Content:
1 x Country-specific power cord, IEC, 6ft
1 x PoE module (10/100/1000Mbps)
Specifications: No. of Ports: 12
Pass Through Data Rates 10/100/1000 Mbps
PoE Output:
Pin Assignment and Polarity:
Data Pairs 1/2 (-) and 3/6 (+)
Spare Pairs 7/8 (-) and 4/5 (+)
Output Power Voltage: 54-57V DC
User Port Power: 72W Typ.
Aggregate Power: 1000W
Input Power Requirements:
AC Input Voltage: 100 to 240V AC
DC Input: 57V (RPS or another 9500G midspan)
AC Input Current: 450W Units: 5.5A @ 110V AC; 2.75A @ 220V AC
1000W Units: 12A @ 110V AC; 6A @ 220V AC
AC Frequency: 50 to 60 Hz
Management PowerView Pro included
Indicators:
System Indicator: AC Power (Green)
User Indicator: Channel Power (Green / Orange)
Connectors:
PoE ports and management port: Shielded RJ-45, EIA 568A and 568B
Console Port: USB Connector Type B
DC Connector: DC Block Terminal
RPS Com Connector: HD-D-sub-15
Specifications: Description: 8 Digital Inputs and 8 Digital Outputs
Digital Inputs: 8
Logic Level 0: -30.0V to +1.0V
Logic Level 1: +2.0V to +30V
Latched Inputs: Triggered by user programmable positive or negative edges, stays true until acknowledged
Counter Inputs: User progammable- counts positive or negative transitions up to 100Hz
Watchdog: Active high/low, Pulsed high/low
Digital Outputs: 8
Digital Output Type: Open drain transistor, protected MosFET. Short circuit protection up to 36V. Over temperature shutdown -175°C typical 150°C min
Maximum Output Load Voltage: 30 VDC
Maximum Output Current Sink: 0.85A per channel
Serial Gateway: RS485 NuDam/ADAM compatible gateway
Number of Ports: 1
Network Port Type: RJ45 Jack 10/100 MHz Autosensing, Cross Over Autosensing (MDIX)
Network Protocols: ICMP, IP, TCP, DHCP, HTTP
Protection: 1500V M...
Specifications: 4 x RJ45 serial ports
10/100 Ethernet
802.3af Power over Ethernet (PoE) compliant
Desktop/wall mount
RS232 interface
Advanced feature set
Specifications: Kit Content:
1 x Country-specific power cord, IEC, 6 ft.
1 x Power adapter
Input: 100 - 240V AC, 50/60Hz 0.6A
Output: 12V DC 2.0A
AC plug: country-specific
DC plug: Right-angle, 2.5 x 5.5 x 10 mm (ID x OD x L) female, positive center
DC cable length 1.5m
Specifications: Power consumption: 1.3 watts via POE
Forwarded PoE Power:
Up to 75 watts depending on standard
Maximum current 0.7 amps on data pairs
Maximum current 1.5 amps on spare pairs
PoE Standards:
IEEE 802.3af POE (15W) and IEEE 802.3at at POE Plus (2-event signature) (25-30W)
IEEE 802.3bt POE (to 75W)
Custom POE (incl. "always-on 48V" and "4-pair" POE)
Ethernet Interface:
Two independently auto-configuring 10/100 ports
(10Base-T / 100Base-TX, half / full duplex)
Patch or crossover cables supported
LEDs Status indicators:
Green LED - shows POE Power good
Yellow LED - shows Ethernet link / activity
Dimensions: 1.22" x 8.27" x 1.97"
Weight: 0.23 lb.
Mounting: 2/4 Bolt 7mm mounting holes. On 50/60mm centres
Operating temperature: -40 degree C to 70 degree C [-40 degree F to 158 degree F]
Relative humidity: Up to 85%, non-condensi...
Specifications: Input Voltage Range:
AC 100 - 240 V
Frequency Required:
50/60 Hz
Interfaces:
1 x Gigabit LAN - RJ-45
Compliant Standards:
FCC Class B certified, EN 60950, EN55024, UL 60950, CISPR 22, EN55022 Class B, FCC Part 15
Compatibility:
HP M200 802.11n, MSM310, MSM310-R, MSM313, MSM320, MSM320-R, MSM325, MSM335, MSM710
Specifications: Ports: 16 RS-232 serial ports
Throughput: Up to 230 Kbps
Signal Support: TXD, RXD, RTS, CTS, DTR, DSR, DCD
Ethernet:
Physical Layer: 10/100 Base-T
Data Rate: 10/100 Mbps
Mode: Full or Half duplex
USB: 2 ports at .5A max per port
Power Input: 100-240 VAC, 50-60 Hz, 0.4A
Surge Protection: 1 kV burst (EFT) per EN61000-4-4; 2 kV surge transient per
Security: SSL, SSL/TLS, SSHv2, FIPS 197 (serial ports), SNMPv2, PPP
Dimensions: 17.00" x 6.95" x 1.62"
Weight: 5.00 lbs.
Specifications: Description: IEEE 802.3af PoE compliant or 48 VDC input from included AC power supply
Voltage: 100-240 VAC
Current: 1.0 / 0.4 A
Frequency: 50 / 60 Hz
Specifications: 4 RJ-45 autosensing 10/100/1000 ports
2 RJ-45 dual-personality 10/100/1000 ports
1 RJ-45 serial console port
Power: 100-127 VAC / 200-240 VAC; 50 /60 Hz
Mounting:
MSM720 controller supports the mounting options of the 2520-8 port, including EIA-standard 19 in. Telco rack or equipment cabinet (rack-mounting kit included); horizontal surface or wall mounting.
Minimum dimensions (W x D x H): 15.95 x 25.4 x 4.45 cm
Weight: 1.64 kg
Form Factor:
Wall Mountable
Rack-mountable
Specifications: Interface
LAN: 1 x RJ45 STP, "Data" Input Port
PoE: 1 x RJ45 STP, "Data + Power" Output Port
AC Connector: 1 x AC input power socket, IEC-320 C6
Network Cable
Ultra PoE (60W): 4-pair UTP Cat. 5, 5e, 6 up to 100m (328 ft.)
802.3af/at PoE (15W/30W): 2-pair UTP Cat. 3, 4, 5, up to 100m (328 ft.)
LED Indicator
System: Power x 1 (green)
PoE Port: Active, PoE ready/in-use x 1 (green)
Data Rate: 10/100/1000Mbps
Unit Output Voltage: DC 56V, 1.08A
Power Requirements: 100 - 240V AC at 50/60Hz, 1.5A max.
Power Consumption: 60 watts max.
Temperature
0 - 50 degrees Celsius (Operating)
-10 - 70 degrees Celsius (Storage)
Humidity: 5 - 95%, relative humidity, non-condensing
PoE Standard:
Ultra PoE over 4-pair UTP cable
IEEE 802.3at Power over Ethernet Plus End-span/Mid-span PSE
PoE Power Supply Type: End-span + Mid-span ...