Specifications: Standards and Certifications:
HDCP 1.1
DVI 1.0
CE
FCC
RoHS2
Signal Input/Output:
Input video signal: 0.5 – 1.0 V p-p
Input DDC signal: 5 V p-p (TTL)
Maximum single-link range: 1920 x 1200, 1080p
Output video: HDMI 1.3, HDCP 1.1, DVI 1.0
Frequency: 1.65 Gbps / 165 MHz
Video Resolutions:
VGA: 640 x 480, 800 x 600, 1024 x 768, 1920 x 1200
DTV/HDTV: 480i/480p/576i/576p/720p/1080i/ 1080p
Specifications: Extends and Distributes HDMI/DVI A/V, Serial and IR Control Signals over Cat5/6 Cabling
Converts source video to IP-based signal transmitted to and distributed through network switch
Transmitter and receiver each extend signal up to 328 ft. (100 m) from switch for maximum distance of 656 ft. (200 m)
Transmitter and receiver can also connect directly without switch up to 328 ft. apart
Designed for Managed Network Switches with IGMP
Allows login and remote management via switch interface
Connect up to 64 transmitters and 255 receivers in single managed switch installation
HDMI output on transmitter for connecting a local display
Enhanced Technical Features
Supports video resolutions up to 1920 x 1080 (1080p) @ 60 Hz
Uses H.264 video compression standar...
Specifications: Interfaces
Serial
4 x Programmable Bi-directional RS-232/422/485 Port
(4 x DB9 Male Connector, configurable via pin assignments);
Baud Rate: 300 to 115200 (default: 9600);
Data Bit: 8 (default) or 7;
Stop Bit: 1 (default) or 2;
Parity: None (default), Even or Odd;
Flow Control: None (default) RTS/CTS
Ethernet
1 x RJ-45 Female, 10/100Base-T
Supported Protocol: ICMP, TCP/IP, DHCP, HTTPS, SSH
DHCP-enabled. The following default IP settings will be used if no IP is assigned within 30 seconds:
IP: 192.168.0.60
Subnet Mask: 255.255.255.0
Switches
Controller ID: 1 x 16-segment Switch
Expander ID: 1 x 8-segment Switch
Reset Button: 1 x Semi-recessed Pushbutton
USB: 1 x USB Type A
Power: Consumption 5 VDC, 7.5 W(adapter) ; 48VDC, 9.5 W(PoE, PoE 802.3 AF/AT compatibility)
Features: Extends either S/PDIF Toslink or Coaxial audio signal up to 990ft (300m) over Cat5e/6 UTP cable
Supplies clear digital audio over long distance with no signal loss
Experience the highest quality audio, compatible with Dolby Digital, DTS 5.1, DTS-HD, 2ch PCM audio formats
PoC (Power over Cable) technology allows both the transmitter and
Specifications: Interfaces
Relay
8 normally open relays (8 x 2-pole terminal block)
Contact Rating: Max 24 VDC, 2A
Ethernet
1 x RJ-45 Female, 10/100Base-T
Supported Protocol: ICMP, TCP/IP, DHCP, HTTPS, SSH
DHCP-enabled. The following default IP settings will be used if no IP is assigned within 30 seconds:
IP: 192.168.0.60
Subnet Mask: 255.255.255.0
Switches
Controller ID: 1 x 16-segment Switch
Expander ID: 1 x 8-segment Switch
Reset Button: 1 x Semi-recessed Pushbutton
USB: 1 x USB Type A (Firmware upgrade only)
Power
Consumption 5 VDC, 10 W (Adapter); 48 VDC, 13 W (PoE, PoE 802.3 AF/AT compatibility)
Output 12 VDC, 300 mA