Network Interface: USER INTERFACE:
Indicator LEDs: Outputs, inputs, communication link and power
Controls: EDID setup button, 12 setup DIP switches
1 RS-232: On a Mini–USB female connector for firmware upgrade
S-Video: VIDEO:
Max. Data Rate: 10.2Gbps (3.4Gbps per graphic channel)
Max. Resolution: Up to 4K@60Hz (4:2:0) 24bpp
Standards Compliance: Supports HDCP 1.4 and HDBaseT 1.0
HDMI Support: Deep Color, x.v.Color™, Lip Sync, 7.1 PCM, Dolby TrueHD, DTS–HD, 2K, 4K, and 3D as specified in HDMI 2.0
Power Consumption: DC5V:1.708W:8BTU/h
DC5V:1.649W:50BTU/ h
Note:
? The measurement in Watts indicates the typical power consumption of the device with no external loading.
? The measurement in BTU/h indicates the power consumption of the device when it is fully loaded.
Specification: Operating Temperature 0°C to 50°C
Storage Temperature -20°C to 70°C
Humidity 0–80% RH, Non-condensing
Local Unit
Upstream Port 1 x USB Type B Female
Downstream Port 1 x RJ45 Female
1 x Micro USB Female (Firmware Upgrade)
Power 1 x DC Jack
Remote Unit
Upstream Port 1 x RJ45 Female
Downstream Port 4 x USB Type A Female
1 x Micro USB Female (Firmware Upgrade)
Power 1 x DC Jack
USB Specification USB 2.0 High-Speed
Cable Type Ethernet Cable
Specification: Maximum Pixel Clock: 2x 165 MHz
Video Input Connector: (1) DVI-I 29-pin, female
Video Output Connector: (1) DVI-I 29-pin, female
Operating temperature range: +5 to +45 deg. Celsius
Power Supply: 5V DC (needed for programming only)
Power Consumption: 5 Watts (max)
Feature: Quick and easy way to store EDID information from any DVI display
Provides a virtual EDID to maintain active monitor status when switching away from a source
Supports resolutions up to 1920x1200, 2K, and 3840x2400 (Dual Link)
EDID write protection switch
No power is required after initial programming
Distance: up to 200 ft. at 1024 x 768 (60Hz)
up to 150 ft. at 1920 x 1080 (60Hz)
Color: Black
LED Indicator: The Green RJ45 LED on the local unit illuminates to indicate it is connected to and receiving power from the source. The Orange RJ45 LED on the local unit does not illuminate. The Green RJ45 LED on the remote unit illuminates to indicate it is receiving power from the external power supply. The Orange RJ45 LED on the remote unit illuminates to indicate it is connected to the local unit and receiving a signal from the source.