DIY Cooling

Limited time offer, ends 06/30

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. With this copper pad to greatly lower gpu temperatures, can be used for graphics, northbridge, CPU chips. It can be used as heatsink solution for Xbox ,PS4 and all laptop and computer such as HP,Dell,Acer,Thinkpad etc. Package included: 10 pcs Thermal Conductive Copper Shims 20mm x 20mm x 1.2mm
• Dimensions: 20mm x 20mm x 1.2mm
• Model #: 11-001-273

Limited time offer, ends 06/30

• Model #: 11-001-360

Limited time offer, ends 06/30

• Color: silver
• Compatibility: CPU
• Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board. These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases. Tested to fit the Raspberry Pi CPU / SoC; Reduce the risk of hardware failure due to overheating. These pure aluminum heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips. These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc. Installation Instructions: -Make sure the chip modules are free from dirt and grease. -Peel the protective liner off on the base of the heatsink. -Apply the heatsi...
• Model #: 11-001-255(10)

Limited time offer, ends 06/30

• Model #: 11-001-014

Limited time offer, ends 06/30

• Model #: 11-001-013

• Model #: BP-NLSF280-F4PB

Limited time offer, ends 06/30

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. And this copper heat sink solve thermal problems caused by frequent crashes laptop, etc Package included: 10 pcs Thermal Conductive Copper Shims 15mm x 15mm x 0.4mm
• Dimensions: 15mm x 15mm x 0.4mm
• Model #: 11-001-267

• Type: CPU Block
• Model #: B-UL-D5-X-V4-CT60-100

Limited time offer, ends 06/30

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Aluminum Heat-Sink, For Package TO-220 / L7805 /LM337 Triode Transistors Cooler IC Chipset Quantity: a lot of 20 Pieces M3 Screw Hole. Size: 19x 15x 10mm/ 0.8" x 0.6" x 0.4" (L*W*H) Thickness" 0.8mm Color : Anodized Black Weight: 2g/ piece Please check the specification table and make sure that the size of the heatsink fits that of your component
• Dimensions: 19x 15x 10mm
• Model #: 11-001-067

• Model #: BPM-VG9070XM

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: 10 pcs of 8.8x8.8x5mm aluminum heat sinks with 3M 8810 Heat transfer Peel and Stick Tape Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc. Come with 3M 8810, is a tacky pressure sensitive adhesive loaded with thermally conductive ceramic fillers that do not require a heat cure cycle to form an excellent bond to many substrates. Only pressure is needed to form an excellent bond and thermal interface. The specialized chemistry of 3M 8810 renders the tape modestly soft and able to wet to many surfaces, allowing it to conform well to non-flat substrates, provide high adhesion, and act as a good thermal interface Excellent adhesive performance with good wetting and flow onto many substrate surfaces....
• Model #: 11-001-393

• Model #: TA-HT12-UPK

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: 10 pcs of 11x11x5mm aluminum heat sinks with 3M 8810 Heat transfer Peel and Stick Tape Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc. Come with 3M 8810, is a tacky pressure sensitive adhesive loaded with thermally conductive ceramic fillers that do not require a heat cure cycle to form an excellent bond to many substrates. Only pressure is needed to form an excellent bond and thermal interface. The specialized chemistry of 3M 8810 renders the tape modestly soft and able to wet to many surfaces, allowing it to conform well to non-flat substrates, provide high adhesion, and act as a good thermal interface Excellent adhesive performance with good wetting and flow onto many substrate surfaces. T...
• Model #: 11-001-394

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: VGA Chipsets
• Features: Aluminum heatsink are generally used in the heat treatment and the fins increase the area of the board and thus provide for greater heat transfer. GPU graphics card Cooling Heatsink Kit is a fan-less cooling solution to any GPU, graphics card, video card. And,Widely use for computer PC chipset, power IC, power electric device, LED light devices, etc. Use heatsink adhesive glue to install heatsink .(Glue is not included) Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name :GPU Video Card Heatsink; Material : Aluminium Color : Silver Tone Package Content : 15 pieces - 8.8mmx8.8mmx5mm Heatsink 10 pieces - 14mmx14mmx6mm Heatsink 8 pieces - 20mmx14mmx6mm Heatsink
• Dimensions: 15 pieces - 8.8mmx8.8mmx5mm Hea...
• Model #: 11-001-128

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: 5 pcs of 14x14x6mm aluminum heat sinks with 3M 8810 Heat transfer Peel and Stick Tape Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc. Come with 3M 8810, is a tacky pressure sensitive adhesive loaded with thermally conductive ceramic fillers that do not require a heat cure cycle to form an excellent bond to many substrates. Only pressure is needed to form an excellent bond and thermal interface. The specialized chemistry of 3M 8810 renders the tape modestly soft and able to wet to many surfaces, allowing it to conform well to non-flat substrates, provide high adhesion, and act as a good thermal interface Excellent adhesive performance with good wetting and flow onto many substrate surfaces. Th...
• Model #: 11-001-395

• Model #: BPM-ENCLP-EVO

Limited time offer, ends 06/30

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. With this copper pad to greatly lower gpu temperatures, can be used for graphics, northbridge, CPU chips. It can be used as heatsink solution for Xbox ,PS4 and all laptop and computer such as HP,Dell,Acer,Thinkpad etc. Package included: 10 pcs Thermal Conductive Copper Shims 20mm x 20mm x 0.8mm
• Dimensions: 20mm x 20mm x 0.8mm
• Model #: 11-001-271

• Type: CPU Block
• Model #: N-ML5090GR-SR-V2

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: Aluminum Heat-Sink, For Package TO-220 / TO-3P / TO-247 Rectifier, Transistor or Regulator IC. Quantity: a lot of 10 Pieces. M3 Screw Hole. Size: 25 x 15x 10mm / 0.98" x 0.6" x 0.4"(L*W*H) Color : Silver Tone Weight: 4g/ piece Please check the specification table and make sure that the size of the heatsink fits that of your component
• Dimensions: 25 x 15x 10mm
• Model #: 11-001-065

Limited time offer, ends 06/30

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Anodized Black Aluminum heatsink for Computer General northbridge ,Southbridge Cooling ,also can be used for cooling graphics card, vidoe card,motherboard, power transistor, FET, IC, power amplifier, Voltage Regulator,etc. The fins increase the area of the board and thus provide for greater heat transfer. Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Size is 28mm x 28mm x 20mm low profile , Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Anodized Black Overall Size: 28 x 28 x 20mm/ 1.1" x 1.1" x 0.8" (L*W*H) Weight: 30g Package Content: 2pcs x Heatsink
• Dimensions: 28 x 28 x 20mm
• Model #: 11-001-327

Limited time offer, ends 06/05

• Model #: 1-Water-Cooling0621

• Type: CPU Block
• Model #: A-AS6700TUF-X

• Type: CPU Block
• Model #: FCMMR-SBK

• Type: CPU Block
• Model #: CP-DDCITN-X

Limited time offer, ends 06/30

• Model #: 11-001-016

Limited time offer, ends 06/30

• Model #: 11-001-293

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc,reduce the risk of hardware failure due to overheating. These pure aluminum heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips. Size is 20mm x 20mm x6mm,Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Silver Tone Overall Size: 20mm x 20mm x 6mm 3M 9448A Heat-conductive adhesive tape is included Package Content: 10 x Heatsink
• Dim...
• Model #: 11-001-060

• Model #: BPTA-SC6T2-PWM

• Type: CPU Block
• Model #: A-RX7900XT-X

Limited time offer, ends 06/30

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. And this copper heat sink solve thermal problems caused by frequent crashes laptop, etc Purchase different thickness copper thermal pad you purpose one-step,default combination: 1 piece - 0.1mm 1 piece - 0.3mm 1 piece - 0.4mm 2 pieces - 0.5mm 1 piece - 0.6mm 2 pieces - 0.8mm 1 piece - 1.0mm 1 piece - 1.2mm
• Dimensions: 15x15mm
• Model #: CU-PAD-KIT

Limited time offer, ends 06/30

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: Widely use for 3D Printer A4988 chipset,computer PC chipset, power IC, power electric device, LED light devices,Raspberry Pi,Banan Pi, Orange Pi,etc,reduce the risk of hardware failure due to overheating. These pure aluminum heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips. Size is 11mm x 11mm x 5mm,Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Silver Tone Overall Size: 11mm x 11mm x 5mm 3M 9448A Heat-conductive adhesive tape is included Package Content: 20 x Heatsink
• Di...
• Model #: 11-001-049

• Type: CPU Block
• Model #: 6932167222374

• Type: CPU Block
• Model #: N-AS5090ASTRAL-X

• Model #: BPM-EP4677-G5

• Color: Addressable RGB
• Model #: DZ-M.2 Cooler-005-01

• Type: CPU Block
• Model #: N-GV4090WF-X-V2