Specifications: This adapter connects a compact flash memory card to a 3.5” IDE host interface. Aiming at educational sectors, IT development, and the embedded technology enthusiast to enable the use of a compact flash card as an IDE hard drive.
Specifications: Mount both PCIe (NVMe) and SATA based M.2 SSDs inside your computer using this PCI Express adapter card
3 Port M.2 SSD (NGFF) Adapter Card / 1 x PCIe (NVMe) M.2 / 2 x SATA III M.2 / PCIe 3.0
PCI Express 3.0 M.2 NGFF Card
Easily expand the storage and improve the overall performance of your desktop or server
Supports PCI Express 3.0 (x4) ideal for a high-performance M.2 PCIe SSD (NVMe)
OS independent with no drivers required for a fast hassle-free set up
Includes a low-profile bracket
Connector A: Connector Type(s): 1 x PCI Express x4 Male
Connector B: Internal Ports: 3 x M.2 (NGFF, B-Key) Receptacle / 2 x SATA (7 pin; Data) Plug
Internal Ports: PCI Express x 4 via full size x 16 pinout
Operating Systems Supported: • A computer and BIOS (usually set to AHCI) compatible with NVMe SSD over PCIe lanes.
• Windows 7 with Microsoft’s Hotfixes for NVMe SSD.
• Windows 8 and above.
• Linux.
• If after installation you get a yellow exclamation mark under the Device Manager, you may need to get an additional driver
Specifications: • Standard 2.5" IDE storage device form factor (100.2mm x 69.9mm x 9.8mm)
• LED indicators: Power On, Master and Slave Card Detect, and Disk Activity
• Can be a primary bootable device containing the OS and applications (depends on CF card specifications)
• Transparent to operating system and does not require any drivers
• Supports Microsoft Windows 2000, XP 32/64-bit, Server 2003 32/64-bit, Vista 32/64-bit, Server 2008 32/64-bit and Linux operating systems
• Power supply via IDE interface (44-pin SFF IDE connector, +5V)
IDE Interface
• 44-pin SFF (Small Form Factor) IDE connector
• Supports Ultra-DMA IDE Interface
• Does not support hot swap on the IDE interface
CF Interface
• 2 CF card slots (Master/Slave) supporting CF Type I form factor
• Supports PIO mode, DMA and Ultra-DMA mode with data transfer rate u...
Specifications: Specification:
Board size: 2.40" x 2.05" x 0.03" (W, L, T)
On-board LED indicators for power-on and compact flash access
Voltage selection for +3.3V or +5V compact flash
Master or slave mode selection
Power input: +5V, floppy disk drive power connector
Fully compatible with Compact Flash Type I, Type II, and Micro-drive
40-way (2.54mm) standard IDE connector
This adapter does NOT support hot insertion of CF cards
System Requirement:
PC or Mac with one IDE connector
MS Windows, Mac OS, Linux operating system
Specifications: 7.5 L x 6.45 W x 1.5 H inches, 0.3 pounds, ICY DOCK, MB305M4P-B, MB204MP-1B, Personal Computer, Laptop, Server, Industrial PC, Workstation