NZXT S340 Matte Black/Blue Steel ATX Mid Tower Case

Pros: Very good looking solid metal case. Feels expensive and well made. Like the blue bar on inside, which covers 24 pin PSU wire and sata wires to mobo ports. A lot of nice zip tie spots for holding wires. It has that modern cover for PSU, so if you have cheap PSU it will be covered up. Same goes for nice looking expensive PSU - no one will see it ;) Cover provides a lot of space for loose wires as well. It have spot to mount Corsair h55 cooling rig with single radiator or dual one upfront, there no fans there, you put fans from radiator on suction, because top and rear one for exhaust and mounted as such. Filters from front and under the psu are nice! For clean intake. Has 2 spots for mech drives 3.5 inch, and couple spots for 2.5 ssd which resting on PSU cover. Back of mobo have almost 1 inch space for wires which are good for cable management. Dual usb 3 on front panel is good, uses single usb 3.0 connector to mobo. Also it has crazy rubber feet ! They like 1 inch tall and super sticky to surface it sits on, it will not slide or shift if you try it. Only pick it up and carry it. I mentioned it has every possible shortcut hole for cable management ? Including back of mobo open thus heat sink install can be done on installed motherboard with out disassembly for back plate switch. At 70 bucks it a good case.

Cons: - tight thumb screws due to poor threading of metal for side panels, you gotta use screw driver. ( its a con because thumb screws suppose to be open by fingers, not screw drivers )
- No 3.5 mech drives rails provided, just screws, where only one side exposed for tightening and requires half size philips screw driver. And for other side of 3.5 caddy you need to remove front panel to place screws. Don't mess up plastic holders for front panel.
- PSU cover not removable, it's a piece of metal that are part of mobo mount.
- 2 x 3.5 inch spaces and 2 x 2.5 inch spaces for ssd drives
- If you will install 1 radiator to the front, you will not fit extra fan under it. It will be like 4 mm short of mounts. So i assume front only for radiators. Ether for dual or single like corsair h55. But i didn't try dual radiator tho.

Overall Review: imho: Very good case for the price. Its nice to build in it, it looks sexy, it has side glass panel. It made with quality in mind. Filters are great. Not to much space for drives , but you should be aware of it, not really a con. Btw stands for mobo are in place for atx board all nine of them :) I do complain a lot, but will not take eggs for it. I like the case, its good price, customer love it, their children love it.... If my clients happy with and it was a breeze to built in it then case gets 5 eggs as rating :)

Pros: The case is a fantastic build. No problems..

Cons: My item arrived damaged with the pci ports bent in the case. Which I had to straighten out.

Overall Review: The expedited shipping took so long a full week for my order to arrive. It was basically normal shipping but I paid extra for no reason.