Corsair CSSD-BRKT1 SSD Mounting Bracket Kit 2.5" to 3.5" drive bay

Pros: Lets you mount a 2.5" drive in a 3.5" Bay. Sturdy metal.

Cons: This one was my bad.... I didn't check the measurements. The length on these is only as long as a standard 2.5" drive (about 4") instead of the full length of a 3.5 drive. This wouldn't be a problem with screw mounting in a bay but can be an issue if your system uses tool less mounting such as in a Dell. In my case the shorter length only allowed for two point connection so I didn't end up using it. Will save for another project where the size lengthwise isn't critical.

Overall Review: If length isn't an issue this is a fine adapter.

Pros: Well crafted solid metal bracket with well machined screw holes. Bracket fit my 6 year old Rosewill case no problem. Bracket is shorter lengthwise than some other 2.5 to 3.5 inch brackets or mounting bays, allowing me to fit it into my case without disconnecting anything else (your results may vary). Mounting my EVO 860 to the bracket's bottom was no problem.

Cons: Screws included would have pierced the side of my EVO 860 SSD when mounting bracket to case from the side closest to SSD. So I only mounted the bracket to one side of the bay using two screws.

Overall Review: Perhaps the bracket screw holes on the side closest to the drive are designed for Corsair SSDs only? Each bracket side has 3 different holes on it to ensure that you'd likely be able to mount 1-2 screws on each side for most cases, although I wouldn't count on it for pre-built systems.