NZXT IU01 Case Accessory

Pros: - Takes one USB 2.0 header and makes three
- Gives two USB 2.0 ports inside the computer
- Comes with Velcro for mounting
- Sleeved USB cable

Cons: - A little bigger than I would have liked

Overall Review: I needed this because I ran out USB 2.0 headers on my motherboard. This splitter installed in about 2 minutes (and then I spent another 30 rerouting cables) and worked immediately and without any trouble. I liked that this comes with a sleeved USB header cable and mounting Velcro. My one complaint is the size. Trying to fit it on the back side of my 750D was not as easy as I would have liked. It was a couple millimeters too big for just about every place I tried.

Overall, this is a solid product good for not only adding headers, but also cleaning up cables as you can mount this behind the motherboard (provided you have the space) and keep all but one USB cable back there.

Pros: Rev2.0 should work as advertised

Cons: Rev1.1 will probably fry your chipset.

Overall Review: The Rev1.1 is known to fry components on the motherboard due to a faulty microcontroller on the Rev1.1 board. It is confirmed that the Rev1.1 was discontinued by NZXT due to so many RTVs with the Rev1.1 board. Rev2.0 is what is shown in this picture but you will most likely receive a Rev1.1 board and chip. NZXT also has a model newer than Rev2.0 that is a magnetic mount rather than the Velcro. It's also cheaper.

Solution: order the IU01 direct from NZXT from their website and save yourself a couple of bucks as well as the hassle of potentially ordering a discontinued, sketchy product.